HP PCG007 Power Supply replacement HP ProDesk 280 288 G3 MT

Buy HP PCG007 POWER SUPPLY 100-240V~,50-60Hz 4.0A 310W +12.0Vmain==16A +12Vcpu ==16A for HP ProDesk 280 288 G3 MT. 100% compatible, quality guaranteed. 1-year warranty, 30-days money-back.

Brand : HP power supply

Input Voltage : +12.0Vmain==16A +12Vcpu ==16A

Out Voltage : 100-240V~,50-60Hz 4.0A 310W

PCG007 replacement model：

PCG007 937516-004

Compatiblet with HP ProDesk 280 288 G3 MT:

MODEL: PCG007

PART NUMBER: 937516-004

AC INPUT: 100-240V~,50-60Hz 4.0A

DC OUTPUT: +12.0Vmain==16A +12Vcpu==16A

MAXNUM POWER SHALL NOT EXCEED 310W

power Size: 95*72*165mm

Power supply interface:

4+4 pin

1x flat 7 pin

3-wire interface

Compatible Models:

For

HP ProDesk 280 288 G3 MT

HP 400G4 282G3 SFF

IT : Alimentatore HP PCG007

DE : HP PCG007 PC-Netzteil

JP : 新品互換用HP PCG007パソコン電源

UK : Replacement power supply HP PCG007

ES : Adaptador del HP PCG007

How to maintain HP PCG007 computer power supply

1. Remove the fan. Disconnect the main power supply first, and unplug the input and output cables on the back of the power supply. Next, unplug and connect all the accessories connected to the power supply, remove the fixing screws of the power supply box, and take out the power supply box. Observe the appearance of the power supply box, remove the screws reasonably and accurately, and remove the cover. When taking the cover, the wires should be pulled out according to the gap at the same time. Remove the four screws that secure the fan and remove the fan. You can not solder the two power cables temporarily.

2. Clean the dust. After separating the power supply board and the fan with cardboard, use a small brush or a damp cloth to wipe the dust and wipe it clean. It is also possible to use dust from the fan to blow fan blades and bearings.

3. Add lubricant. Peel off the sticker and use a needle-nose pliers to pick out the rubber seal. Find the motor bearing, add lubricant, and when you use the fan to move the fan, make the lubricant flow evenly along the bearing, then add a few drops. Pay attention to whether the fan of the ball bearing has two bearings. Don't neglect the oil feeding to the bearing on the wind side. The oil can't be placed on the main shaft only. Lubricating oils must use computer-specific lubricants or advanced lightweight sewing machine oils. Never use the lubricants used in automobiles. Finally, install the rubber sealing sheet and label it.

other products

Dell 3WN11 1x 24-Pin ATX 12V

HP 503376-001 100-240V-/4A.50-60 Hz

Lenovo HKF1502-3B 200-240V 240V 3.0A

HP 445102-002 100-240V~ 50Hz-60Hz.5.0A MAX

Dell RM112 100 - 240V